Those running Kirban's full billet fuel regulator, need a favor

[trbojo]

.485 on my mic.

7/16 works out to .4375... the .047 difference could be in fuel pressure difference.....

 

[TR Custom Parts]

All is good, fuel pressure was at 43 lbs line off. Plenty of clearance to that plug I installed.

 

[trbojo]

Mark, question for you...i have a 4" inlet turbo....I'm going to need a maf pipe to use with a 3.5" ls1 sensor. do you have an angled coupler to clear my up pipe? it's a precision front mount, and pretty tight now with the stock sensor...or will i need the plenum riser?

 

[turbobitt]

Need people to place more orders so I don't have any spare time.

Great, so how about my request ?

Allan G.

 

[TR Custom Parts]

Great, so how about my request ?

Allan G.

Allan I emailed you back about it. $10 each and $15 for the one with the hole drilled for you. Send me a Paypal payment to trcustomparts@gmail.com

 

[TR Custom Parts]

Mark, question for you...i have a 4" inlet turbo....I'm going to need a maf pipe to use with a 3.5" ls1 sensor. do you have an angled coupler to clear my up pipe? it's a precision front mount, and pretty tight now with the stock sensor...or will i need the plenum riser?

Would recommend a 3.5" MAF pipe and get the optional 4>3.5" connector. Should clear, hell I have a 4" MAF pipe on mine and it clears my 3" up pipe. Only "spacer" I have is a RJC power plate.

 

[turbobitt]

Allan I emailed you back about it. $10 each and $15 for the one with the hole drilled for you. Send me a Paypal payment to trcustomparts@gmail.com

Mark,
Sorry, never got the e-mail. Even checked my spam box and junk e-mail folders. Can you resend ? If you require a surcharge for special order then I'm OK with that cause I know I may me asking for a lot.