I've got alot of valve train noise... usually bad when comming down from high RPM's, but can hear it at idle too.
Springs look stock, so I'm assuming it's a stock cam and such. Looks like a set of springs arn't that much, so I figure.. WTH... give it a shot.
Most here seem to recommend replacing the springs anyway, so... I've been looking around, and am wondering what would be a good way to go for a stock setup?
I'm eyeballing Kirbans HD set.. cheap and comes with the tool meant for Buicks. Just wondering if anybody uses them.. are they good, is there a better choice?
Any advice is appreciated.
TIA
Springs look stock, so I'm assuming it's a stock cam and such. Looks like a set of springs arn't that much, so I figure.. WTH... give it a shot.
Most here seem to recommend replacing the springs anyway, so... I've been looking around, and am wondering what would be a good way to go for a stock setup?
I'm eyeballing Kirbans HD set.. cheap and comes with the tool meant for Buicks. Just wondering if anybody uses them.. are they good, is there a better choice?
Any advice is appreciated.
TIA
