Wheel Studs

[mr84ss]

Whats up family. Im doing my rear disc conversion and im needed the correct wheel studs. I know they have to be atleast 1/4 longer than the factory studs. Do anybody the the correct part #'s for the studs because these folks at the parts stores are no help

Sent from my LGMS631 using Tapatalk

 

[Chuck Leeper]

I buy the ARP studs from Summit. I don't recall the knurl size. New lug nuts when I do the swap. I use Mcgards.

 

[detaildave]

i just did this 2 weeks ago . I had to buy larger stud's ARP with a larger Knurl , and ,I took them to a local driveline shop and had the axles drilled for the new studs , and the studs cut at the same time , I searched high and low for the longer studs ,with the correct knurl size and had no luck .I was however able to use my standard lug nuts , Good Luck , Dave

 

[dynoman]

These might be a little longer than needed . The knurl size I used was .509" and they pulled in fine . My old stock studs measured .496" knurl 1.49" under head length . Hope this helps , Sam
https://www.summitracing.com/parts/arp-100-7708/overview/

 

[mr84ss]

These might be a little longer than needed . The knurl size I used was .509" and they pulled in fine . My old stock studs measured .496" knurl 1.49" under head length . Hope this helps , Sam
https://www.summitracing.com/parts/arp-100-7708/overview/

That link isnt working on my phone

Sent from my LGMS631 using Tapatalk

 

[dynoman]

Just tried it on my phone and works . Go to summit racing and in the search box put in ARP 100-7708 .

 

[mr84ss]

Yea i figured its something wrong with my phone.

Thank you guys for the info

Sent from my LGMS631 using Tapatalk