Where to tap into MAP sensor for Power Logger

[Sweet6]

Like the title says. Is there a wire I can tap into close to the ECM so the logger can read boost? Or where should I tap into the MAP wire?


TIA

 

[Quiky One]

Which car is this on? TTA 259 with alky or TTA 1216 without?

 

[Sweet6]

TTA259 with alky.

 

[Quiky One]

In that case tap off the MAP wire you ran into the car for the alky controller. The same signal is needed for the powerlogger. Thats what I did and it works great.

Jason

 

[Razor]

In that case tap off the MAP wire you ran into the car for the alky controller. The same signal is needed for the powerlogger. Thats what I did and it works great.

Jason

+1

 

[Sweet6]

Thanks. I was just curious if there was a MAP wire under the dash to tap into like the GN.