You can type here any text you want

Who's running a Revolution XR4 220-224 Hyd Roller Cam in a stroker ?

Welcome!

By registering with us, you'll be able to discuss, share and private message with other members of our community.

SignUp Now!
Sounds like it will work. Who you buying it from?

it's a FT cam , I'm getting from another board member . :) I think with the extra cubes with a stroker it should be fine on the street as well . I was trying to find someone who maybe running one on the street/track .
 
no one has feedback on this cam?

I emailed Mike at FT about this cam asking about any "downsides" to this cam and this is what I got back .
:)
"It will work good in a stroker motor, you will need to run it to 6200 to 6500

Mike"
 
It's been almost a year since the last post in this thread. I'd like to hear comments from anyone running this cam. I know it'll make power high in the RPM range, but how much did your low end suffer? Were you able to see any differenes in your 60' times?

Thanks.
 
I have this cam in a Stock stroke 109 with ported irons, champion ported strock intake, 60lb inj, 70mm tb, 1.65 t&ds, ta-62, 3400 stall, 3.27 gears, th350 with t-brake. With a 10lb launch and 18lbs boost it has gone 7.42 in the 1/8 with 1.62 60ft. i will be installing a pt70 in the next week and will report back after i turn it up. So far ive been impressed with it.
 
Might depend on what ratio of rockers he runs. I have the 210/215 (.516" lift) with the 1.60 ratio HS rockers and no problems at all here.
 
Back
Top