Recent content by cimi4749

TPS was .52 so I adjusted that back and started it up got it up to temp and it didn't glow. Anyone care to look at the scanmaster log? Thanks, Joe

Quick vid I took after I turned it over.

Thanks for everyone's input, it is beyond appreciated. I'll have some time to check things out tm. I have a scanmaster g and can do a log and post it here. Just to address a few items: - injectors were just cleaned and flowed before install -not getting a ces light -can anyone recomend what...

Just buttoned up and ran the motor after head gasket failed at cylinder 3. Started up fine, chased down a coolant leak at the heater box and then found this... scary.

You're a life saver. Thanks!

I took it all apart and didnt take any pictures! Can someone point me to a good parts diagram that shows me how to get all the accessories back on? Thanks!

I had thought so but couldn't possibly leave it to "eyeballin" it. Thanks!

Any recommendations on where to get the boot?

Guys I screwed up the order of the pushrods when removing my drivers side head. What do you recommend I do on reassembly? Thanks Joe

That's a fairly far haul even if i take the ferry. Sent from my SM-N900P using Tapatalk

Im with Joe! Prefferably one who can tune Big stuff 3 and e86. Sent from my SM-N900P using Tapatalk

Pulled the wiring harness off and this one hiding behind/below the O2 sensor lost/melted it's rubber boot. Sent from my SM-N900P using Tapatalk

Got my nice new SMG in today and it looks great! I can't understand how the last owner went without a scantool. :facepalm: With that said I'm having trouble getting it to communicate with my phone which was the entire reason for the purchase. See pics attached. Thanks!

I can make an offer on everything. Is this still available?

Just did it. I met the seller at the u.s. border. Some paperwork had to be taken care of. Other than that it was stupid easy. Sent from my SM-N900P using Tapatalk