Recent content by Brooks

Hi Scott, not really interested in trades.

Sorry for the quality of the pictures they were taken with a friends camera phone. I've received several PM's and emails and I think I've sent duplicate responses to some of you, sorry about that. I'll try to answer all the questions here... Yes the steering wheel is rough, I have a...

A few pics... I have a replacement steering wheel as well. :)

Car has 184K, engine was rebuilt by a past owner but I have no documentation on it. I have a lot of extras that go with the car. Went through a divorce last year (Yes I kept the car, and damn near everything else too!!!) and as it turns out the car was my major excuse to avoid the evil wench...

Dave Warren's Fast Lane Performance is a new vendor on turbobuick.com. located in Brandywine Maryland. Door opened early in 2000 providing custom fabrication services. We have a certified EMIC on staff and have extensive experience in EFI installations and unique EFI and...

The PDF version of the ecm diagram on gnttype is much easier to read. Try this http://www.gnttype.org/techarea/ecmsensors/ecm3.PDF I printed it out with an inkjet and all the wire colors, pin numbers, and component lables are legible.

Alright, but lets wait a couple days to give ineeda38turbo a chance to decide. Charles Brooks

I have a servo from Chris at CK Performance. It's brand new, my tranny builder said he was unfamiliar with it and prefered to use a GN servo. I'll sell it for $75 Charles Brooks

I use a stock actuator. I drilled an additional mounting hole to offset it a bit for better alignment of the rod. Charles Brooks

If the bung is for a wide band I think it's likely threaded M18 1.5 Charles Brooks

Dan, I'll take those. Give me an address to send payment to and I'll get it out in the mail right away. Charles Brooks

Does anybody know of a good guide for adjusting the windows on our cars? Mine rattle pretty badly and wind noise is intolerable above 60MPH or so.

Problem found I found the problem, one of the intercooler hoses had blown of and the pipe was misaligned. After puting everything back where it belonged car fired up and ran nice and smooth. Charles Brooks

My car decided to start giving me problems again this afternoon. This time with no hints as to what direction to begin troubleshooting. The car will start but dies almost immediately unless I play with the throttle. Direct Scan shows no codes, fuel pressure is rock solid, I have not done any...

Hi all, I have a PTS shift kit, pressure regulator system, and blue clutch rebuild kit in my transmission. Since the rebuild the transmission rarely (almost never) downshifts into 1st gear when coming to a stop. After coming to a dead stop if I bump the shifter into nuetral and back into...