Recent content by Caddy63

Hello folks, I have a TH350 in my regal, 7.5 rearend. I have found a 8.5 posi that was used with a th200r tranmission. Will this driftshaft be correct for my TH350/8.5 rear application? Anyone know what the lenght should be for the TH350/8.5 application? Is the transmission yolk the same for the...

rearend I asked a week ago about the rearend...PM'd also. 1Baad6 you still out there?

Bump!

rear 1Baad6, I pm'd you, what will you take for the rear end? Thanks, Scott

rear Where in Michigan? What will you take for the rear end? How many miles? Thanks, Scott

rear Would you consider shipping the rearend? I am near Indianapolis. Thanks, Scott

Hello, I have a line on a 8.5 posi rearend. The gentleman tells me it is a 2.73 gear. Will a lower gear (higher number) fit in this rear with minimal hassle? I am looking at 3.23 or 3.55. Thanks, Scott

Hello folks, The SBC 355 is in place and running in my 81 regal. How about the heater fan and the vacuum for the heater controls? Do I just hook a vacuum source in to the small vac line? I assume that that will make the controls (defroster/vent/floor) diverters work. Which wire in the mess of...

Hey fellas, I am getting my parts in line for my 355 sbc into a 81 regal swap. The donor car is an 82 camaro. Both cars have a 7.5 rear end in them. The regal has 2.41 non posi gears, the camaro 3.23 (best guess) posi setup. My question is can I swap the rear end inner center section into the...

Hello folks, I am getting ready to replace a tired 3.8 in an 81 regal with a 355 N/A. Do the mounts need to be moved fwd on the car? Seems to me it should bolt up in the stock location, but a buddy tells me I need to move them. Maybe a turbo next year, one step at a time. Thanks, scott

Does the carb turbo motor have beefed up internals like the FI trubo motors? How costly is the FI unit later down the road, can FI be installed on previously carbed motor? Thanks for the info, Scott:rolleyes:

Hello Fella's, Long time lurker, 1st time poster. I have a clean 1981 regal 45K miles. I have found a carburated GN motor, not sure what year. It has the harness and the computer with it. Is it a PITA to go from NA to this carb turbo motor? I have Fabricating skills, but just was looking for an...