Recent content by MikeV

  1. M

    F/S Kirban Rear Seat Frame Brace Kit - new

    PM returned to affordablegn. If that falls through, I'll work my way down the list. Thanks guys!
  2. M

    F/S Kirban Rear Seat Frame Brace Kit - new

    Just found this while cleaning out the shed. Never been installed. Comes complete with all attaching hardware and instruction sheet. Kirban sells these for $72.95 + shipping. I'm selling this for $55 to your door.
  3. M

    F/S 1987 GN w/front end damage - $4K in Kansas

    Thanks for all your help Brian. It is much appreciated. :wink:
  4. M

    F/S 1987 GN w/front end damage - $4K in Kansas

    Car has been sold. Thanks for playing!
  5. M

    F/S 1987 GN w/front end damage - $4K in Kansas

    Sold pending funds.
  6. M

    F/S 1987 GN w/front end damage - $4K in Kansas

    All calls and PMs answered! INEEDAGN - That's what long term debt is for! ;)
  7. M

    F/S 1987 GN w/front end damage - $4K in Kansas

    Here are some pictures from before the minivan pulled out in front of me and just stopped. They show the paint job a little better w/o all the tree reflections and such.
  8. M

    F/S 1987 GN w/front end damage - $4K in Kansas

    Classification and Listing Type Classification: Street Car Listing Type: For Sale Vehicle Specifics Year: 1987 Model: Grand National Exterior Color: Black Interior Color: GN (Grey/Black) Interior Material: Cloth Interior Smoking History: Unknown VIN: Title Status: Clear Number of...
  9. M

    GNX Style wheels

    Should that be a link to your ad, cuz it isn't. :confused:
  10. M

    Changing Motor mounts

    I was going to do my motor mounts too and, after a lot of research, did it the easy way. Change the driver's side mount and call it good. I've never tried the passenger side mount, but heard it's much harder to do. I used a Napa mount on mine. Even though it wasn't as hard of a mount as...
  11. M

    Pump ALWAYS running

    You were right, I had tapped the green wire into the wrong place under the dash. I undid it and ran the green wire out to the MAP sensor and now it works like a charm. Now if only I can make this wastegate go higher than 17 psi... Thanks!!
  12. M

    Pump ALWAYS running

    Ug, didn't change anything. One last question, then I'll call you tomorrow afternoon. For the ground wire on the pump, I attached it to the pump bracket screw on the back of the pump. The bracket is aluminum. Will that work? The O-ring connected to the wire was too small to fit around the...
  13. M

    Pump ALWAYS running

    I just finished installation of my Razor's alky kit, and turned the key to the ON position to run the tests in the installation guide. The pump is running. Constantly. I can turn the little knob and hear it speeding up, and it will shut off if I turn the little knob to the OFF position. Any...
Top