Stage 2 headers
More info on stainless steel headers are they ATR or other and for stock or buick stage2 heads. And material used to make the headers 304 or 321 stainless steel thanks. Here is my # if you prefer to call 805 760- 0865.
stage 2 headers
Who old are the ATR single and dual stage 2 headers and have they been repaired because by the picture i see looks like they been mig welded not tig welded in some areas.
Need information and feed back soon as possible with the CP Pistons that i am using for my stage 2 motor.My problem and concern is the clearance between the bottom of the piston and top of the Carrillo 6.5 on center rod. I took pictures so you guys can see if i will be running into problems...
Was wondering if the Federal Mogul rod bearing # 6-7120CH -10 have a upper and lower bearing because there is no marking on the rod bearing that tells me which are the upper and lower bearings?Also want to make sure that the piston valve relief are toward the top on the block and the Carrillo...
Under drive pullies race
First in line for the race set underdrive pullies here is my address julionrocha@yahoo.com.Do you have paypal account or where do you want me to send the money thanks.
What method are the buick guys using for setting the new piston ring on the stage motors.Like installing them dry in the bores,oil the skirt with 10-30w but not the pistons,or oil the skirt and spry WD 40 like the ring manufacture says thanks.
Stage 2 headers and Dowu pipe
Geno nice work on the stage 2 headers what size primaries are they and what brand merge collector did you use like SPD or burns? I wll be making mine shortly need feedback on merge collector and primery size. Are 2 inch primeries better than 1 7/8 ones?Go with 304...
What piston gaps are you guys running with forged CP piston and total seal rings? Manufacture specs say with a 4.0 bore x .0055 blown gas* =0.22 top ring and 4.0 x .0035 second ring = .014 is this a good ring gap.Also do i need to get Quickseat or use WD-40 to seat the piston rings thanks.
Need help on the main cap back seal big block chevy 2 peice seal and also part number or the name of the guide strip that go on the rear main cap on the two sides.I am talking about the two machined grooves on the cap? Also need cam pictures fully assembled with all parts needed so distributor...
Anyone have pictures of Danny Bee or Duttweiler cam trust plate that holds the cam in place in the front cover. Need to drill and tape for the retainer plate.Looks like there is on really one way to drill and tape the hole locations thanks.
Hi GN owner i am going to be in Tampa for the Superbowl half time show and would like to see if anyone near Tampa has GN with stage 2 on center block that i can look at so i can get ideas on my stage 2 on center block build thanks. Here is my cell phone # if someone knows anyone 805 760 0865.:D
Stage 2 on center 153 block and stage 2 headers
How much for the on center block and the twin stage 2 headers? Any kind of damged done to the block like sleeves or pan rail work?
chapman stage 2 indy ported heads
How much do you want for the indy ported heads and are they pressure checked,machined for what valves 2.08 and 1.6 with 40cc and are they ready to just bolt on? Will you be willing to trade?