Recent content by TheHitman!

Mine is available.. PM sent to you.

I will pull it off this weekend... G body have all been yanked up here to make race cars... And they throw the not needed parts like this away... :(

Sounds like it is time to go to pull a part.. I might as well get the entire motor. I wonder what cars I should look for and what years? Getting 87 parts around here is getting harder and harder.

When I turn the wipers on they come on... But when I turn them off they don't stop... I turn the switch on and off and nothing and then finally they just stop. The wipers witch is a bit pricey so I would like to make sure if it is it or not ahead of time. not to mention pulling the steering...

I can see clearly now..... That is exactly it... I will buy some more vac line and locate it in the car.. Will make it allot easier to make changes. Thank you all.

Thank you to both... Here is the problem. The part with adjustment has one port "top one" as a vent port and the bottom one as a line port. Then the T has a through and through and the side port is made on. So I am wondering if the boost from the turbo goes to the made on port of the t and the...

I just needed a simple boost controller and picked up one of these. I don't race...I just like to spin the tires every now and then. Anyways these do not come with anytype of instructions... On the part with the nob the top port says vent.. Bottom shows out. So does the supply line from the...

Thank you everyone... I have no emission stuff here so I am good to go...

So no issues with a check engine light if I take it off?

I have my block off plate and want to get rid of the egr stuff. The canister is already gone for the tin man intake. I have a TT chip for alky but just do not know what to get rid of and what I have to keep if any. I have looked through here but just cannot make out some of the post on this.

Coolant moves to quickly and will cause an overheating problem. Put a good 160 in it and flush the system well.

I am planning on installing a manual boost controller on my car. If I do will I need to still use the y setup or just go from the turbo to the controller to the wastegate? My wastegate solenoid is not working and I am not going to pay 300 for one.

I bought GM sweeps and putting them on. I was very happy to see that I did not have to take the windows out.

Steering wheel sold... Thanks Kyle

$20 for shipping. turbo6@bellsouth.net is the address.