nos487
Member
- Joined
- Jan 24, 2004
- Messages
- 107
I hate to do it but times are hard and need to sale pretty quick. The car runs good but needs some paint and interior work. In the last few months after buying car this is what I have done to it, all parts where bought new.
Scanmaster
60 Motrons
TT E85 chip
TT street chip
LS1 maf
Translator
K&N
RJC power plate
160 thermostat
340 Walbro hot wired
3'' down pipe
3'' single exhaust (used)
Vacuum brake swap
New pads up front and serviced bearings
Turned rear drums
Flushed trans fluid
Flushed coolant
Changed rear diff
AC delco plugs
AC delco pvc
Felpro intake gasket
Felpro valve cover gaskets
Intercooler hoses
All vacuum hoses
Drivers motor mount ( have new pass.)
Tie down
Moog rear springs
Two front tires
I think this is all I have replaced I pulled carpet and put in trash. The only rust I can find is in pass. floor and bottom of doors. I have a good passenger door that goes with car. I also have extra bumpers and an extra intercooler. If I can think of any thing else I will update. I would like to get $5000.00 OBO. Send email for pics.
Scanmaster
60 Motrons
TT E85 chip
TT street chip
LS1 maf
Translator
K&N
RJC power plate
160 thermostat
340 Walbro hot wired
3'' down pipe
3'' single exhaust (used)
Vacuum brake swap
New pads up front and serviced bearings
Turned rear drums
Flushed trans fluid
Flushed coolant
Changed rear diff
AC delco plugs
AC delco pvc
Felpro intake gasket
Felpro valve cover gaskets
Intercooler hoses
All vacuum hoses
Drivers motor mount ( have new pass.)
Tie down
Moog rear springs
Two front tires
I think this is all I have replaced I pulled carpet and put in trash. The only rust I can find is in pass. floor and bottom of doors. I have a good passenger door that goes with car. I also have extra bumpers and an extra intercooler. If I can think of any thing else I will update. I would like to get $5000.00 OBO. Send email for pics.
