ttypewhite
Well-Known Member
- Joined
- Oct 1, 2001
- Messages
- 4,159
I am unloading these pistons I had in one of my old 4.1 motor. These pistons DO NOT work with stock stroke motors. It needs a 3.55 crank and a 6.35, or 6.30 rod. These pistons were new and have 3 weeks run time on them. Had the washer from the cam sensor fall in the front cover when I was repairing a busted cam sensor pin on the gear. Didn't realize it fell in the motor and put the new sensor in. That washer sand blasted inside the motor. The pistons look ugly from the bottom, but has nothing to do with its strength and integrity. Take some time to clean and prep these pistons and you will have a decent set. I would replace the rings, but that's your decision. Anyway the specs are:
4.00 Bore
.990 PIN
1.530 Comp Height
Anybody building a budget 4.1 build I am going to sell these pistons, rings and pins for $225 shipped.
top
Side (has some score marks, but not deep and rough)
bottom of all pistons
4.00 Bore
.990 PIN
1.530 Comp Height
Anybody building a budget 4.1 build I am going to sell these pistons, rings and pins for $225 shipped.
top
Side (has some score marks, but not deep and rough)
bottom of all pistons
Last edited:
