86/87 parts, and a few more 84/85 parts

[fullahotair]

86/87 Parts:

Intercooler with shroud - $50
IC FAN with bolts - $25
IC brackets (two) - $50

Set (6) of 2 dot rods - $35



84/85 Parts:

84/85 ECM - $30
Engine Harness-$130
IAC,TPS sensors - $20 for both
Stock intake with water neck - 20
Ported intake (ported by me), cleaned - 30
Valve Covers -$25
Turbo Adapter - $30
14 bolt oil pan - $35
Oil Pump pick up tube and screen - $25

BRAND NEW GM - Front Cover for a 14 bolt pan - $100

Aluminum Accessory Bracket - $30
Fuel Injector Harness - $35
Fuel Rail - $25
Water pump and crank pully - $15 for both
Intake duct work with MAF and K&N cone filter - $60
Fan Shroud - $30
Coil Pack and bracket - $35
Alternator - $25
2 Hydroboost units, both for $150
AC Compressor with lines - $40

Parts are located in Syracuse, NY. All prices are flexible..some are more than others... and DO NOT include shipping... I have pics upon request.

Thanks,
N8

 

[Jerryl]

84/85 Parts:

IAC,TPS sensors - $20 for both
Stock intake with water neck - $20

What is the condition of the TPS and IAC?
Is the 87 oil drain shield (?) available?
Turbo drain tube?

 

[fullahotair]

The TPS and IAC were in working order when removed, so they should be good.

No 87 oil drain sheild...sorry..

The oil drain tube you see in the one pic is for an 84/85 and is for sale as well, but i forgot to list it. $15 bucks for the drain tube??


Let me know,

thanks,
Nathyn

 

[Jerryl]

The TPS and IAC were in working order when removed, so they should be good.

No 87 oil drain sheild...sorry..

The oil drain tube you see in the one pic is for an 84/85 and is for sale as well, but i forgot to list it. $15 bucks for the drain tube??


Let me know,

thanks,
Nathyn

Also ......
Can you measure the resistance values of the coil pack?

 

[fullahotair]

Sure i can try and do that for you. Give me a few, and i'll go out and see if can't figure it out....


Thanks,
nathyn

 

[fullahotair]

Terminals:
3/6 - 11.90ohms
5/2 - 11.92 ohms
1/4 - 11.70 ohms

Thanks,
Nathyn

 

[Jerryl]

U have PM

 

[GN84Turbo]

Whats the condition of the fuel rail? Any knicks/dings/dents? Threads good? mounting holes good? TIA

 

[fullahotair]

This is the only ding i could find. It was my 90K car, prior to removal. No issues while on the car, and I checked the threads, mounting holes and all seemed fine, minus a little dust. Lemme know...


Thanks,
N8

 

[burnout]

What condition is the harness in? Does it have the ALDL port also.

 

[fullahotair]

I am heading off to work right now, but i can give it a closer work when i get home this afternoon. It was used on my car before i took it apart with out any issue. I would be using it over if i wasn't going IC. If the ALDL port is integrated into the harness it is included. I'll have to check on this to be certain.

Thanks!
NAthyn

 

[blueridgebully]

coil pack module

do have the 84 coil pack module?

 

[fullahotair]

blueridgebully...

I am sorry, perhaps i am having a brain lapse...but the coil pack module? do you mean something other than the coil pack listed above?? If not, I am sure I have it, as I dissambled my entire running engine...

Let me know,
Thanks,
Nathyn

 

[fullahotair]

Here are some pics of the wiring harness. Only noticed two items worth mentioning. The TPS sensor has the sheathing stripped in a small section where a volt meter was used to read the volts. The other is on the knock sensor wire near the ECM. This was was tapped into for a knock sensor, but is currently taped up. Otherwise no issues with wiring harness. I have most of the plugs marked with where they go.

Price is negotiable... let me know...thanks!


Nathyn

 

[artrenee10]

Whats the condition of the alternator....is it for an 87?
LMK
Thanks
Steve Chambers

 

[fullahotair]

alternator is for an 84/85....and in good working order...


Thanks,
Nathyn

 

[fullahotair]

Any reasonable offer on this stuff will not be refused...it needs to leave the garage!!!


Thanks,
Nathyn

 

[hcox10]

a/c

hi
does the a/c comp. work excel. and hoses no leaks.
i will give you 25$.
thanks harold

 

[fullahotair]

The AC pump worked just fine when removed. The system needed charged, but otherwise was fully functional and blew cool air. The square lug bracket used to tighten the pump is not included. $25 plus shipping and its yours. If you would like to see some pics, let me know and i'll send them your way.


Thanks,
Nathyn

 

[hcox10]

a/c

send photo how much ship 60458.
thanks harold