A while back I converted my brakes to Vacuum from PM. After the conversion the AC would not turn on. I have power to the compressor, but missing continuity on the ground circuit. I momentarily installed a jumper to ground, the compressor started and the system blew cold air, as well as controlled on and off.
Question is, where is the ground point for the AC compressor plug ?
I can easily install another ground to the compressor plug, but would rather have the system wired the way it is supposed to be. Not sure if I knocked off the ground wire when replacing the PM or not, don't see any extra or loose wires hanging around.
The wiring diagram shows the negative wire just going to ground from the compressor so installing another ground should not cause an issue ?
Any help would be appreciated.
Question is, where is the ground point for the AC compressor plug ?
I can easily install another ground to the compressor plug, but would rather have the system wired the way it is supposed to be. Not sure if I knocked off the ground wire when replacing the PM or not, don't see any extra or loose wires hanging around.
The wiring diagram shows the negative wire just going to ground from the compressor so installing another ground should not cause an issue ?
Any help would be appreciated.