Aftermarket boost gauge pics

[pvt num 11]

I'm getting tired of my boost gauge being an inaccurate piece of factory junk. Can people with aftermarket set-ups post pics of their vacuum/boost gauges and a brief description of what went into it? I'm leaning for an a-pillar set-up, but I'm open to suggestions. Also, if I decide to go that route, what other aftermarket gauges/warning instruments are recommended?

EDIT: I kant spel

 

[Jan Larsson]

I got a Autometer one (Z-series http://hp.autometer.com/products/zseries/mechanical_gauges/mechanical_gauges.html) 20 PSI there is a 30 PSI one as well in the same series.

Clean install, ground and +12V then the tube for the boost (just T in where the MAP sensor is connected to the vacuum block).

A piller I got a nice spare from the junk yard I cut a hole in and attached the pillar pod.

 

[Jan Larsson]

And another picture

 

[Lunkan]

I like the 3-pillar pod

Those are Boost, trans temp and EGT (from bottom and up)

Sorry if the car looks messy, we´ve just welded the rollbar.

 

[j13smiley]

nice! i'd like to get a 2 guage pod... boost of course....not sure about which to pick for the secone... tranny temp or something? what would you guys pick for #2?

 

[MSA231V6]

nice! i'd like to get a 2 guage pod... boost of course....not sure about which to pick for the secone... tranny temp or something? what would you guys pick for #2?

Depends on your primary application for the car I suppose. Coolant temp and oil pressure come to mind as two to pick from.