Alchohol & HEET mix

[PaulRV6]

Hi folks, I have a DIY kit using the common Shurflow pump and M10 nozzle on the up pipe. My question is I normally run 50/50 mix of water and denatured alchohol. I was at walmart yesterday and picked up a bottle of HEET (yellow) and was thinking I could thro it in the mix. Would this be beneficial or harm things? Would I have to do anything different?
Or should I just run straight denatured alchohol? Thanks

paul

 

[Razor]

Whats wrong with what your currently doing necesitating a change?

Your asking to change mixtures, then play with denatured and methanol, then go to straight... your all over the place.

Focus on one thing. And go from there. You designed your own system.. go figure it out with your car. Nobody on the planet over a keyboard can tell you what to do with what you created except "Tune for no knock". Nozzle size, pump pressure, line diameter, electrical connections, etc etc etc are to varied on a DIY systems to offer any credible advice.

HTH

 

[PaulRV6]

Ok thanks, how about if I ask another way.

Can I mix heet with my 50/50 mix (water/alchy) without any problems, is it compatible together? I may just keep the 50/50 mix but in case I wanted to change. Thanks again

paul

 

[Razor]

alky is basically alky. Especially when mixing. So whether you use denatured or heet.. its all the same.