razor,
i set up the logging kit with the gauge, my settings are as follows: gain- 36.75 offset -18.375
based on the xfi manual for a .5-4.5 volt sensor these should be accurate(0psi=.5 volts and 147psi=4.5 volts). problem is at key on the sensor is reading .33 volts hence showing me -6 for alky psi at idle. Is this something to be concerned about? i understand im just looking for a trend of pressure throughout the boost curve but i would like to have the pressure as accurate as possible. Thanks
i set up the logging kit with the gauge, my settings are as follows: gain- 36.75 offset -18.375
based on the xfi manual for a .5-4.5 volt sensor these should be accurate(0psi=.5 volts and 147psi=4.5 volts). problem is at key on the sensor is reading .33 volts hence showing me -6 for alky psi at idle. Is this something to be concerned about? i understand im just looking for a trend of pressure throughout the boost curve but i would like to have the pressure as accurate as possible. Thanks