Alkycontrol - Power Injection bulb

[meanchicken]

Well....true to form....I found a way to screw this up.

I was installing the "power injection" bulb and one of them skinny little leads busted clean off at the base of the bulb. No way to repair it....

So I put in a request to Razor to please expedite me a new one....but that'll be a few days at least before it arrives.

I was hoping to have this done today and I'm already on world record time ...the longest that is ....started at 10:30AM....it's going on 7PM....still plugging away between family distractions and runs to various stores for little things.

Don't suppose anyone knows where I could get one of these bulbs fast..?????

 

[SPOOLFOOL2]

Now ya done it!

Try Radio shack. Or, Marvac on Harbor Blvd. in Costa Mesa.

And, QUIT BRAKING STUFF!

 

[meanchicken]

Thanks, Spoolfool.
I'll try Radio Shack tomorrow and go from there....

I was made to break stuff...it's what my purpose is.
I've made a career out of it.

True!

 

[WeSS]

bulb

If you need it right away you can go to gettozone or advanced and get a two pack 12 volt bulb similar in size and just solder on the red/black wires that were on the bulb you had received. Reinstall it in the PI slot. Good to go. It basically goes across the pump and as the pump spins up the light gets brighter.

 

[Razor]

194 Bulb. Any 12volt lamp will do.

HTH