Any luck with plastic ls1 maf?

[TurboBuRick]

I tried one before and had issues. Replaced with a aluminum sensor and resolved.

Has anyone had any luck with the plastic ls1 maf??

TIA

Rick

 

[Len8827]

I have the plastic LT1 (3") on my car for two years. No issues

 

[1952ray]

LS1, one year, no issues

 

[Pronto]

What issues did you see? I have tried one and would occasionally get a MAF code. I don't know if the Translator is going flaky or if it was the MAF. I have a new Translator and metal LS1 MAF to try when the weather breaks.

 

[TurboBuRick]

It was a while ago. I want to say I had idle and off idle issues.

Just swap the maf and see what happens. No?

 

[Eric Stage I]

I've had very good luck with them. You might have coincidentally got a bad one, or some other issue. I only use the plastic ones anymore (unless it's a blow through setup).
Eric

 

[TurboBuRick]

How about when you lift the throttle? Any issues with back pressure triggering fuel?

 

[Pronto]

I would go for weeks and not have a code and other times it would throw one several at a time. I'll start with swapping the metal one in. Plastic one has no air foil, maybe that is causing it to flake out?

 

[Turbo6Smackdown]

What ever happened to your maf issues guys? And which setting on your translator did you use? Also, what is off idle issues? I seen the setting on the translator but have no clue what it means. The directions aren't the most comprehensive.