Anyone using BuickGN.com Mark Hueffman gauge panels above the glove box?

[John Wilde]

I manufacture a gauge mount that uses existing holes in the dash frame and alters nothing - no cutting or screwing in to anything in the dash.

I believe it is the only mount that holds three full sized gauges near the dash that does not block the windshield or the HVAC Vents.

That looks very nice how much?

 

[Blown&Injected]

Thanks!

I just made some in order to get it just right and have not thought about a price for a finished part but it looks like I should do that before this week is over. Indeed, I was thinking about doing it again with a bit of angle but also thought if it was needed, the angle rings already available should work.

Also planned to finish the back side with some vinyl upholstery material that looks like it will match the gray in a GN.

I have been thinking about getting a few products together for our cars and just finished a piggy-back harness for the VOLT light.

 

[ChavoLC2]

Gauge holder

I manufacture a gauge mount that uses existing holes in the dash frame and alters nothing - no cutting or screwing in to anything in the dash.

I believe it is the only mount that holds three full sized gauges near the dash that does not block the windshield or the HVAC Vents.

That's really some clean work, very nice. Here'a pic of ours not as clean as yours, but holds 3 gauges and vent still operatable, Boost gauge mounted a tad higher so it would be line of sight . So everything is mounted a little higher but that allows the Razor Alky control to squeeze in right under the gauge holder/mount.

 

[Blown&Injected]

old thread alert...somebody was asking about an old gauge thread