Anyone using Remflex gaskets ?

[DoubleD]

I only blew mine when a bolt fell out, other than that they worked very well.

 

[Jay J]

You have to be careful not to flex or bend them--very fragile.

 

[TurboSmart]

Well, they arrived today and installed them today.

The package says to torque them to 20, no 15 or 17.

I trimmed a little bit around the header ports and the installation was easy..probably because I have become an expert swapping gaskets now.

Let you guys know the outcome

 

[turbo nasty]

Retorque them a few times after heat cycles

 

[TurboSmart]

Ok..back to 20 lbs ft?

 

[TurboSmart]

Well, after a 160 mile trip yesterday the gasket worked flawlessly.
I have a very small pinhole leak but that is on the crossover pipe and driver side Vband

So next step is a torque check and keep checking.

 

[SPOOLFOOL2]

I don't believe that they requite a re-torque. You might check their site to confirm. Please post up what you find. I've never re-torqued them.

Mike B.

 

[TurboSmart]

at only 20 lbs/ft is quite low.
a slight snug to confirm the torque will not hurt..