J
JS87GN
Guest
I hope someone can help me. I am installing Bell Tech Spindles on my 87 GN, I have the new spindle bolted on with a floor jack suporting the lower A arm the spindle rubs the upper A arm and when I lower the jack and remove pressure from the lower A arm the spindle won't move at all.
Called Bell Tech and talk to them but all they had to say was finish putting it together it will be fine
but my problem is if I leave hard off the line am I going to be able to steer my car.
Can someone help or had these problems?
Called Bell Tech and talk to them but all they had to say was finish putting it together it will be fine but my problem is if I leave hard off the line am I going to be able to steer my car. Can someone help or had these problems?
Good luck with the spindles.
