BigStuff3 Calport help *urgent*

[Curturbo]

I am hoping somebody on here may be able to help me out on this one. I lost my calport cable before finishing my project and I just got the car running on the basemap but it sucks and it needs to be tuned. I am trying to get to the track tomorrow which means BS3 won't be able to get me one by then so I am gonna make one. If somebody out there can tell me by tracing there's it would be greatly appreciated. I'm almost positive that the 3 wires from the calport connector (white or gray, black and red) go to pins 2,3 and 5 on the rs232 db9 serial connector as shown here... "arcelect.com"/9_PIN_PIN_OUT.GIF" ---without the """

I just want to make sure before i go ahead with any customness. Thanks much.

 

[Curturbo]

to clarify... the serial side of the connector is the one that i am questioning. I need to know which of the 9 pins on the serial connector refering to my picture goes to which color. It's gonna have to be done with either a test light or multimeter and possibly a paper clip to get inside the serial connector to check for continuity. Thanks