BMS crank hub, Scorpian rockers, Crower rods

[forcefed3.8's]

Buick Motorsports internal balance crank hub like new, came on ane engine I bought, I went with a BHJ, it might be new. $150 shipped

Scorpian 1.6 ratio roller rockers for GN1 heads. used in good condition includes screw in studs, nuts, guide plates $175 shipped

Crower billet On center wide journal 6.35" connecting rods. Can be machined for off center, narrow journal. Brand new in the box Cost $1200, $850 shipped

I accept paypal and MO's. Shipping to the lower 48 only

 

[turbotony1]

PM sent on Crower Rods

 

[forcefed3.8's]

rods
Can't find the card, but measured the ends:
big end thickness .895" (wide journal)
big end dia 2.225"
Pin end thickness 1.125"
Pin end dia .927"

 

[750H.P.V6]

Are you sure about the big end dia? If it's 2.225" then it would be for a 2.100" journal dia. 2.100" is a rod journal for a SBC not Buick.

Neal

 

[forcefed3.8's]

You are right. It didn't even think about it yesterday when I measured. If anybody has any use for these, make an offer.

 

[87action]

roller rockers

Will those rockers fit the old M&A heads, do they have different offsets for the pushrods? thanks

 

[forcefed3.8's]

Some are offset, not sure about fitting M&A heads.

 

[forcefed3.8's]

TTT

These rods will work with an older offset ground stroker crank, and some oddfire cranks. Will take $500 for them.

 

[forcefed3.8's]

Taking offers on all parts. I will be at the BPG show Saturday.

 

[forcefed3.8's]

$150 shipped for the rockers
$250 shipped for the rods
$150 shipped for the hub

 

[TurboWh1]

Sent you a PM on the balancer.

 

[magee]

pm about rockers

 

[forcefed3.8's]

rockers sold pending payment

 

[re-evaluating]

Email sent

 

[forcefed3.8's]

hub sold