Champion ported/polish heads

[Blacky]

Back in the late '90s we put a ring in the head. Hold the stock gasket together better. Has anybody ever tried to mill that ring out of the head?
Steve c

 

[Sweet6]

I have not done it but I know a lot of people have.

 

[Blacky]

Any of those people that have dealt with this issue, can you chime in

 

[xlr8ngn]

I have read where people put a copper wire in instead of steel, and the copper deforms and fills in the groove to run stock gaskets. I am not recommending this and have not done it myself, but worth researching.

 

[Jason dcpt]

Weld it up and mill it off. I would imagine that ray would do it.

 

[BUICKTIME]

I asked this question before and received mixed reviews. I was told by someone I know personally that he did mill them down to remove the groove and had nothing but problems but some say it will just boost compression with no issues. I'd leave them alone and just run the correct gaskets. I've over boosted plenty of times and never blew a head gasket with 30+lbs of boost @125mph. GL