Clunck is gone......

[Steve V]

Yes,the dreaded 3-2 clunk is gone. I had to remove the PTS pin,reinstall the stock pin and cushion spring. Shifts are great and downshifts are hardly noticeable. I still used the PTS servo. Best trans I built yet.:biggrin:

 

[jakeshoe]

Yep,
You gotta have the cushion spring.

I'm not sure why anyone would suggest removing it. You can get super hard 1-2 shifts with the spring in place, too many other ways to get there if desired to even consider removing the spring.

 

[cnoble64]

Bad 3-2

Please tell me if you are talking about the old stock GN pin and cushion spring. And do you have the new purple pts servo. Thanks.

 

[jakeshoe]

Yes,
The stock pin and cushion spring from the GN or any 200-4R.

Pin length needs to be correct, and an adjustable pin is a neat idea but not worth leaving the cushion spring off.

 

[cnoble64]

Thanks!

 

[Steve V]

I am using the purple servo.

 

[cnoble64]

Thanks to you both, I will try mine Saturday with my fingers cross. I just spent alot of money in this tranny, and can't stand the clunck. Thanks for sharing this good info.

 

[Steve V]

I am VERY pleased with my trans,I hope you will be too! CK and Pts parts threw out.

 

[SNOWBIRD]

I installed a billit servo from CK per his specs ,,,no clunks nice tight shifts

 

[cnoble64]

Steve V, I just found the time to Install the cushion spring today. I really want to thank you for the post and the help. I am like you for the first time, can say that I am really happy with my trans. I spent a lot of $$$$$ on something that I was not happy with. AGAIN THANKS!!!

 

[Steve V]

Good job!