I have been previously having issues with my rpm jumping around while accelerating, cruising and decelerating. I changed coilpack/ module, re-set cam sensor. After doing that still no luck. I finally decided to pull up pipe off and found a very minimal amount of oil in TB with a strong fuel smell. I cleaned out and also cleaned IAC (note: the intercooler and up pipe were spotless). I unplugged all connectors to veryify pins were straight and not corroded. Disconnected wiring harness to gen 7 adapter and diconnected harness from gen 7.
Now that my quick inspection was complete I hooked everything back up and there is no start. I double checked every connector.
I am getting proper fuel pressure and the engine is cranking. All fuses checked out ok. So now I've added another problem.
I am going to re look everything tomorrow in the light, but I am I missing something stupid?
I am able to communicate with ECM through calmap and there are no codes showing.
Now that my quick inspection was complete I hooked everything back up and there is no start. I double checked every connector.
I am getting proper fuel pressure and the engine is cranking. All fuses checked out ok. So now I've added another problem.
I am going to re look everything tomorrow in the light, but I am I missing something stupid?
I am able to communicate with ECM through calmap and there are no codes showing.