Dash harness

[ALL PRO V6]

If I were to switch from a digital dash to analog what would I have to do if anything to the harness?


Thanks Mac

 

[ALL PRO V6]

Ttt

 

[ALL PRO V6]

Does anyone have any input????

Mac

 

[GNVenom]

Don't do it unless you have the entire analog dash harness.

They're two different animals.

 

[ALL PRO V6]

Is there anyway to put the other harness in and where can I get it?

Thanks Mac

 

[GNVenom]

Try Jay's Grand National, T-Type, GNX Performance Parts and Repair for a used dash harness. I believe they have them.

 

[Grumpy]

I have some to

 

[ALL PRO V6]

Grumpy what do you need for one of the harnesses you have? Do you just plug in or what?


Mac

 

[Grumpy]

$185 shipped .. stock harness

 

[jdpolzin]

Just swap with this guy! The dash harness isnt that bad to swap. Just have to take the dash apart and put it back together. Not too bad! Just some screws to take out and put back in. You will also need a sending unit to replace you MAP sensor.

http://www.turbobuick.com/forums/general-turbo-buick-tech/167230-analog-digital-dash.html

 

[pacecarta]

he is doing digital to analog ,

only good way is with an analog dash harness , gauge pack

remove dash with harness attached (theres a bunch of stuff to do before pulling one out and im sure theres a step by step list somewhere on the net , do a search) then remove existing harness , install analog harness , reinstall dash and then install the analog gauge cluster connecting speedo cable , check eng lamp and vss to back of speedo

also if you want the boost gauge to work you'll need to remove the hobbs switch on passenger fender and install a two bar MAP sensor and plug in (the wire is already there and will become active once the dash harness is swapped over , and connect the vac /boost line to it
not sure what needs to be done to make the fuel gauge read accurately since the digital has a different sender in the tank.