Dennys HD Alum. Driveshaft w/TH400 yoke

[Analyte]

Denny's HD Aluminum driveshaft built for a TH400 with solid 1350 joints and tranny yoke. Only has ~2000 miles on street only.

Center u-joint to u-joint is 58 inches. When built an overall length measurement of 61 5/16in from the end of the trans case to the flat surface on the pinion yoke was specified.

It is in perfect shape and cost $525+tax+shipping when new. So this is a deal for someone at $400obo

Email me for pictures if interested.


Kerry

 

[PhilM]

I am interested... I'll just have to check my length this weekend. Why you selling it anyways?

Thanks
Phil

 

[Analyte]

I spun a bearing in my motor so since its out I decided this would be the perfect time to change over to a T56. The yoke and length will be different so I'm letting it go and then I will get a nitrous ready unit built to deal with the clutch dumps when it's all installed.

Thanks and please let me know.


Kerry

 

[Analyte]

ttt