ECM Harness and connectors

[aminga]

Ok. I'm attempting a little science project to build a plug and play adapter for my ISAC. Anyone have the Vehicle side ECM harness with about 6" of wire entact.

Anyone have an idea of were to get the male connector like the ECM board

 

[pacecarta]

go to a boneyard, find an 80s gm fwd and cut the connectors off while you're there grab the ecm even if its not a 7148 ,

the wire colors and pin locations used might vary from ours but you should have enough wires with pins to swap to fit our pinout
for the female side you can remove the black plastic ecm connector off the ecm motherboard.

im sure caspers would also be able to supply what you need as you'd basically building an ecm jumper like he built for the maftpro to make it pnp

 

[aminga]

go to a boneyard, find an 80s gm fwd and cut the connectors off while you're there grab the ecm even if its not a 7148 ,

the wire colors and pin locations used might vary from ours but you should have enough wires with pins to swap to fit our pinout
for the female side you can remove the black plastic ecm connector off the ecm motherboard.

im sure caspers would also be able to supply what you need as you'd basically building an ecm jumper like he built for the maftpro to make it pnp

I've browesed casper's site and saw the harness side but not the ECM side. I'll go back and look again.

 

[pacecarta]

yeah i saw the con ne ctor ends too, $$$ , time for a trip to the junkyard
btw dont need to limit search to fwds the s10s and most all gms from 87-92 would have what you need