ECM wire connector

[Jerryl]

I am in the middle of a install and got some GM mini wire connectors (2 types) at the local store.

Anyone one have a picture of the correct wire harness connector?
I tried removing one out of the connector but not sure how (I know you need a special tool)

Anyone ever remove one of these or know what the pin looks like?

 

[Jerryl]

Most may never need this info but for the 'few and the proud" , here is pic of the connector.

 

[turbofish38]

That looks like the terminal used on the ECM connector. The male(??) half would be a pin the width of the wire used on a paper clip. They make those in different sizes and gauges of wire. They are usually classified by width in mm. I.e. one and one half millimeters is a 150 series,2.8 mm is a 280,etc.

 

[Jerryl]

That looks like the terminal used on the ECM connector. The male(??) half would be a pin the width of the wire used on a paper clip. They make those in different sizes and gauges of wire. They are usually classified by width in mm. I.e. one and one half millimeters is a 150 series,2.8 mm is a 280,etc.

Yes, it is for the ECM.
I am adding the ECM electric fan control.

 

[BRAD_PADGETT]

Sent you an email with a PIC. Brad