FAST 2.0

[Chuck Leeper]

Been a loooonng time since and need a bit of info.
Have downloaded the software and am trying to adjust the axis values.
The instructions say a finger pointing, I get a hand grabbing the number. NP changing it but the 'interpolate" feature has to have both the start and end values set. With this done, the interpolate feature is greyed out.
This download is from the FAST site and is shown as "Demo mode". Does demo mode block the interpolate out, or??

 

[turbo nasty]

Been a loooonng time since and need a bit of info.
Have downloaded the software and am trying to adjust the axis values.
The instructions say a finger pointing, I get a hand grabbing the number. NP changing it but the 'interpolate" feature has to have both the start and end values set. With this done, the interpolate feature is greyed out.
This download is from the FAST site and is shown as "Demo mode". Does demo mode block the interpolate out, or??

You have the dash populated with the values of the table? Have to have that

 

[Chuck Leeper]

Looking closer, the hand actually has a finger extended.
The tune is an existing tune that I'm converting from E85 to 93/alky.

 

[~JM~]

Looking closer, the hand actually has a finger extended....

By any chance is it the central digit?

If so... That's not a good sign.

 

[Chuck Leeper]

By any chance is it the central digit?

If so... That's not a good sign.

Like this one?
No, it's like this one!

 

[norbs]

There is no interpolate feature on the axis, they are manual entry only.