fast wiring?


May 25, 2001
i'm using a fast inductive p/u for my turbo sbc
do i need to run a crank trigger or can i get the signal from the msd distributor?
if some one can guide me how to wire the system using
msd distributor, msd7al box, fast inductive p/u system, and a two step
does the signal go from the distributor to the fast then to the msd7al? how does the timing get retarde?

Yes, you can use your distributor for the crank signal. The purple wire from the dist goes to the red wire on the crank sensor input and the orange wire goes to the black wire. The points wire in the FAST harness goes to the points input on the MSD box. Two step is wired normally. The timing is controlled by the values entered into the spark table.