First Powelogger File

[highboostgn]

First file after putting my motor back together . It said was running 30psi but my gauge said a constant 15.. There is no way it was 30

 

[HouTX87]

My boost reading is also higher on the powerlogger than the boost gauge. Here is a link for the fix. I haven't done this yet but plan to soon. I have the analog dash.

http://www.vortexbuicks-etc.com/PowerLogger.htm

 

[highboostgn]

My boost reading is also higher on the powerlogger than the boost gauge. Here is a link for the fix. I haven't done this yet but plan to soon. I have the analog dash.

http://www.vortexbuicks-etc.com/PowerLogger.htm

Thanks for that!

 

[HouTX87]

Thanks for that!

No problem. I stumbled on that a while back and it's been lingering in the back of my mind.

 

[Eric Stage I]

Which wideband do you have? Also, you have your target a/f for low gears set to 11.7. I would move that back down to the default 10.8 while you get things straightened out.

 

[highboostgn]

Autometer. I haven't changed the setting on the chip yet

 

[Eric Stage I]

Did you reprogram the Autometer output to match a PLX?

Your target A/F for the low gears is not at default. I would reset the ECM, and make sure the settings go to default.

On the boost, do you have a 3 bar MAP sensor connected?

 

[highboostgn]

I saw a post on here by bob bailey and he said the autometer output is the same as the arm. So I selected that in the dropdown box. Yes on the 3 bar. What was the output of the plx? I ll try changing that up on the gauge

 

[Eric Stage I]

If you look in the instructions for the 6.1 chip, it talks about the Autometer and how to set it up.