Flywheel Holding Tool

[hemi8]

Does anyone know if a flywheel holding tool like the one below or another style is available for our V6 to hold the flywheel while tightening the balancer bolt?

Mike

 

[CS99]

https://shop.advanceautoparts.com/p...5Ah5B7q-oQIZRK-GjVoaAi42EALw_wcB&gclsrc=aw.ds

Sent from my VS987 using Tapatalk

 

[pacecarta]

buick v6 uses same starter as as chevy LT1 motor so a holder for LT1 would work... https://www.ebay.com/itm/Gen-V-LT1-...e-holding-locking-tool-USA-MADE-/291807072059

 

[hemi8]

buick v6 uses same starter as as chevy LT1 motor so a holder for LT1 would work... https://www.ebay.com/itm/Gen-V-LT1-...e-holding-locking-tool-USA-MADE-/291807072059

Perfect, thanks Paul!

Mike

 

[pacecarta]

i would contact seller and check to see if it does earlier LT1 . one other thing to note is the bolts supplied may be meteric and youll need SAE

 

[Nick Micale]

Vise grip pliers will work as well!

 

[Jerryl]

240 ftlb impact wrench.
To tighten . . . Oil free threads both sides . . . .Blue loctite, go 6-8 "ta ta ta ta's"

 

[TexasT]

240 ftlb impact wrench.
To tighten . . . Oil free threads both sides . . . .Blue loctite, go 6-8 "ta ta ta ta's"

What if we are using ugga duggas or braps, how many then?

 

[Jerryl]

What if we are using ugga duggas or braps, how many then?

Depends how loud they are. Hahaha

 

[Fast4Ward]

Wedge piece of wood works good too.


Sent from my iPhone using Tapatalk

 

[Turbo Archie]

use old arp rod bolts in the crank and hold with a long pry bar.