GN ECU Boost Contol External Gate

[sdteb]

You will likely want to get a 2-circuit weatherpack connector to make the solenoid plug into the stock boost solenoid connector.

I have the solenoid with the connector pre-installed on my site

Hi Boost Solenoid – Bailey Engineering

Bob

can this be used on the ecu gn?

 

[GNVYUS 1]

I have ECUGN, Turbosmart 50mm wastegate, Bob's solenoid and connector but connected to the EGR plug due to my boost solenoid being a PIA.

Great control, I set it up so that 0% duty cycle I get 15psi for safe pump gas runs and 60% I believe is 22psi but tapers off so tuner scaled it up from 5k on to flatten that out. If you wanna run really high boost then you'll want higher 0% starting spring like 17psi etc so the scaling responds slightly higher every 10%.