hobbs switch

[Dr.drivability]

what do you guys use as a vacuum source for your hobbs switch??

 

[IrvJr]

I use the motor. Best when its running.

 

[rodman99999]

A 'T' between the steel vacuum line and the line to the MAP sensor.

 

[87granny]

A 'T' between the steel vacuum line and the line to the MAP sensor.

x2

 

[MSDGN]

I tapped into the line going to the charcoal canister...just make sure you tap the line in between the motor and check valve.

 

[Jeff Rand]

I am looking for an adjustable Hobbs switch. Most of the switches that I have seen are fixed. Any ideas where I can purchase one?
Thanks,
Jeff

 

[howdies86]

Napa P/N 701-1608. This is an old P/N but it may still be good. Note: Use to break the ground only! Otherwise you will blow fuses. I found out the hard way.Howard.

 

[1dollardog]

I use the motor. Best when its running.

I don't care who you are, that was funny right there!

 

[TurboDave]

I am looking for an adjustable Hobbs switch. Most of the switches that I have seen are fixed. Any ideas where I can purchase one?
Thanks,
Jeff

Most are adjustable. Like the one pictued in this thread. You just pull out that little rubber cover (on the upper end of the one in the picture) on the end, there's an adjustment inside, takes a fairly sizeable hex wrench.