How to bleed a powermaster...????

[BLACK MAGIC RACING]

Hello again. Boy , I tell ya, i'd be soooo lost without this board... anyway, i'm changing my powermaster today and was wondering how to bleed it, and the lines, as i've never done any brake work of this type before. Thanks again, Guys!!

 

[Black Car]

To bleed the master cylinder, you will need the plastic adapters that screw into both the outlets on the unit and tubes for the adapters. Most remfg or rebuilt PM comes with them, if not then you will have to borry or buy some.
Anyway connect the two hoses to the two adapters and run them back into the resevoir that has fluid in it. Have someone slowly pump the brake pedal till there are no bubbles coming from either tube.
Then remove the adapters and connect the two brake lines.
Then you will need to bleed all four wheel cylinders just to be sure that all air is removed.

Gary

 

[Jimn8or]

Bottom of this page will help you out.
http://www.gnttype.org/techarea/brakes/PwrMstr.html
HTH
Jim