How to replace PM Accumulator?

[TurboTnZ06]

Is there any trick to replacing the accumulator ball on the PM? It seems like I would unscrew the old one and screw the new one on. The label says to pump the brakes ten times. Where is a set of instructions on the proper replacement procedure?

TIA

 

[Black Car]

Pump the brake peddle till it goes hard usually 6-8 times. This releases the pressure inside the ball.
Put a rag under where the ball screws in. It will drip a drop or two when you remove the ball.
Unscrew the ball and MAKE sure the O-ring comes out of the PM hole.
If not, use pick to remove the old o-ring and then just screw in the new ball.
That is it.

Gary:smile:

 

[TurboTnZ06]

Cool!