?ignition break up starts at 4500rpm

Welcome!

By registering with us, you'll be able to discuss, share and private message with other members of our community.

SignUp Now!
Bob
I need the install directions for my box
Instructions are long gone
Was installed I think by cal long ago

I don't see all these wires and splices to disable it

Is there any easier way to remove it?
 
The bailey side with the most wires that has a gray and a white wire at ECM and those two bailey wires splice into ECM and other white wire runs into harness
Are these the two wires I splice back together?
 
the manual can be downloaded here:

http://2step.bailey-eng.com/

to remove, look in the fusebox under the drivers side of the dash, there should be a cable plugged into the CCCI fuse location. remove that and install a fuse.

on the signal cable, if the white and gray are spliced into the ECM harness, disconnect them and reconnect the harness wire (it will be white)

Bob
 
Clay, I think I installed that. I will be out of town for a couple weeks with the new job but can help you when I return now that I'm caught up with life lol

Posted from the TurboBuick.Com mobile app
 
Back
Top