Is anybody running an ATR Dial-A-Boost?

[1BUICKT]

If so Im hoping someone could answer a question that I have about its harness. The four wires that go into the weatherpack connector from the controller are a red, a white, and two black wires. Im assuming it then goes to a harness which runs into the engine compartment and plugs between the boost solenoid and the boost solenoid's red connector as maybe a white/black and a red/black? My question is which is going to what plug? Im wanting to make a harness for my ATR controller and need to find out which wires need to be crimped to which connector. Is it the red/black or white black that goes to the female, male, etc.

Thanks,
Johnny

 

[MG8T7GN]

Here are the directions, if it helps. If they aren't clear enough, I can dig mine out of storage.

 

[1BUICKT]

Here are the directions, if it helps. If they aren't clear enough, I can dig mine out of storage.

Yes, those do help me from what I can read as for the recommended installation. Thank you very much. Im still really hoping though that somebody has this hooked up on there car, it would save me some trial and error time.

 

[1BUICKT]

I'm back at it again so seeing if anyone hopefully has any helpful info about the harness.

Thanks,
Johnny

 

[1BUICKT]

Bump