Lowers are boxed and bolt holes reinforced and I was expecting a tight fit. Dug through some threads and looks like it may be a herb adams bar? I want to know if its even for a gbody. Might be getting a hr bar sooner than later.When I had that bar I had HR lower control arms and the big bar was right up to them, in fact I had to grind them down some they wouldn't push the arms out. I wouldn't run that arrangement.
Thank you, great info. This sounds like what I have. Ill have to figure out how to make a wedge shim. Using these washers i have 5 in the front and about 15 in the back. I think this bar measured 35 or 36 mm. Its been a few weeks.I have Herb Adams sway bars on my car, 1 5/16" front and 1 1/2" rear. I believe the ATR rear bar is only 1 3/8". I ordered them from summit racing the spring of '88.
It recall the listing in the catalog was for A and G bodies. The rear bar did come with a tapered wedge shim for each side that attached using both bolts, it was a tight fit. Mine is mounted to Kenne-bell lift bars.
I haven't had any troubles with mine, I thought if I did I would weld the shim/ spacer to the control arm.
I would make a tapered wedge shim and run it.
I like that. My Spohn sets lower than that. I'm just waiting for it to hang on something.