To launch the LM programmer:
Plug the supplied cable to the computer, plug the 1.5 mm jack to the LC-1 female cable jack.
Turn the ignition key to on.
Launch the program on the computer.
For the calibration read the LC-1 manual closely. Also make sure the calibration button and led are hooked up per the LC-1 installation instructions. I had the LC-1 stuff already installed on my caspers Plug n Play harness for the Maft Pro, so I can't help you with that part if the previous owner installed it. If you can't find it, call the previous owner.
Plug the supplied cable to the computer, plug the 1.5 mm jack to the LC-1 female cable jack.
Turn the ignition key to on.
Launch the program on the computer.
For the calibration read the LC-1 manual closely. Also make sure the calibration button and led are hooked up per the LC-1 installation instructions. I had the LC-1 stuff already installed on my caspers Plug n Play harness for the Maft Pro, so I can't help you with that part if the previous owner installed it. If you can't find it, call the previous owner.