You can type here any text you want

low 10sec built 109 motor complete/ misc(turbo/convertor/intercooler/electronics

Welcome!

By registering with us, you'll be able to discuss, share and private message with other members of our community.

SignUp Now!

84gnolds

New Member
Joined
Apr 7, 2008
Messages
1
engine: 3.8 GN block(109)
40 over je pistons(plascermic rings),K1 rods,steel crank,comp cams custom cam112/112(flat tappet), harland sharp1.6 roller rockers,cometic head gaskets,percision ported heads/intake, bhj sfi balancer,j/w flexplate, 3 steel mains,arp main studs,head studs,70mm tb,kenne bell doghouse,83lb injectors.
headers. runs good 80psi oil pressure cold 40psi warm runs 170 all the time. more built right,freshly serviced, has been 10.20/10.30 on 20#. runs 11.5's on street tune(13#'s) complete TB to pan:7000$ shipping avalible


PT70 turbo,turbonetics deltagate wastegate,manual boost controller
3bolt to headers 4 bolt on downpipe(700shipped low miles well taken car of)

coan 3500 stall convertor(350$shipped)

2 1/2-3" intercooler piping(painted gloss silver),V2 large front mount intercooler (500$ plus shipping

translater plus w/ls1 maf(250$ shipped)
computer w/extender extreme race chip(83lb injectors tuned by(bob bailey)(25degrees timing in rev limit)100$ shipped or maybe include with motor
msd dis4 w/interface(complete with coilpack and wires.(450shipped(with instructions)
lm1 wide band w/new o2 sensor(250$ shipped)(with intructions)
scanmaster 2.1:(150shipped)


all prices not set in stone.
717-669-2606 motor still in car
 
coan convertor

1st in line on the convertor pls. Can you pm me more info on it, ie.... miles, lock up/NL, part # possibly, balloning plates?, 10"? and it is for a 200r4 correct?

Thanks justin
 
scanmaster

2nd in line for scanmaster please if the deal falls through
 
convertor is for th350 trans 10" antiballon plates cost 600$ new 3,500miles on everything
 
Back
Top