Need an idea to plug the akly nozzle hole in the up pipe

[Toby_Goodmk]

I am removing my alky injection (E85). Any ideas out there to plug up the hole, that wont look too bad??

 

[1986 Buick GX1]

A stainless steel button head allan bolt with a jam nut loctited and peened on the inside? With some sealant, of course. The inside could be cleaned up with a die grinder if desired.
The head could be painted to match your up pipe as well, if not polished.

 

[Boostrules]

I am removing my alky injection (E85). Any ideas out there to plug up the hole, that wont look too bad??

Why are you removing it? Just curious.

 

[scgnx2]

Why not post in "parts wanted" for one not drilled, might get lucky and be able to just swap parts with someone going alky injection.

 

[TurboTGuy]

Why are you removing it? Just curious.

He's going to E85 fuel and shouldn't need it anymore as E85 is 107+ octane out of the pump.

Although I will say, E85 is getting harder and harder to find in my area.

 

[Toby_Goodmk]

Why are you removing it? Just curious.

Using E85

 

[Toby_Goodmk]

Why not post in "parts wanted" for one not drilled, might get lucky and be able to just swap parts with someone going alky injection.

its a front mount intercooler with a custom pipe

 

[TT/Ameasap]

Weld it

 

[Toby_Goodmk]

decided to look in my bolt stash and discovered some flat garage door fasteners that were 1/4'-20. Cut the excess thread off, loctite red, good to go. Barely notice.

 

[TurboTGuy]

Good enough for military work..........

 

[Boost231]

F that, pull it off and weld that shit. You'll wish you did if that ever comes loose and goes into the motor like those damn accufab throttle blade bolt heads did.

Sent from my SM-N930T using Tapatalk