No Start

[Demps]

I've read every post and link I can find on the subject.

Original car (and owner) minus new(er) coil pack and wires and cold air intake.

Battery was dead then charged. Car is in storage.

Car has NO SPARK, good fuel pressure and the injectors are firing.

C3I Module (under coil) connector shows 12 volts on 'p' but nothing on any others. Crank sensor pins show nothing when turning engine over.

I bought a new coil and module at Autozone for a quick-fix attempt--Nothing.

Old coil ohmed out good. Wires good. Plugs okay. No spark on any.

Please help.

thanks,
Ted

 

[BoostedEvIL]

check oil pressure switch, coolant sensor and cam sensor?

 

[cabech984]

What about the Electronic Spark Control (ESC) module(flat square module w/ connector.) Its located on the passenger side by the HVAC Box.

 

[Rodney87GN]

CCCI fuse blown?

 

[turbo tom]

what is the CCCI fuse blown

I have the same problem, car will not start.I have spark and fuel pressure.

turbo tom

 

[turbo tom]

where is the oil pressure switch?

 

[SuperCPA]

where is the oil pressure switch?

Its located on the passengers side of the block around the same level as the waterpump where the head banks 'V' off from the block core. Its 14" NPT.

 

[turbo tom]

Would That Cause It From Starting?

Turbo Tom

 

[Matt McClung]

The oil pressure switch has a bypass circuit for the fuel pump, so if the fuel pump relay is not working then as long as the engine has oil pressure it will supply power to the fuel pump, but you say you have fuel pump operation so this is not your problem.

I was looking at the wiring diagram and pin M on your ignition module connector is pnk/blk and supplies 12 volts to your coils. and this circuit has its own fuse labeled ccci fuse 10A. If you have no power to pin M then your coilpacks get no power. I am attaching a diagram of your ignition system.