Old school Holley valve covers

[ES1]

May or may not polish up.
Will also need rubber grommets for the oil breathers.
65.00 shipped.
Have pics, email me at eshelton@hotmail.com if interested.

 

[ES1]

pic

pic

 

[Darkcyde]

wonder would those fit gn1 heads?

I love old stuff, very cool!

 

[ES1]

Not sure, I tested them on the stock heads and everything matched up.

 

[charlief1]

They'll only fit with stock rockers unless you use the jrc spacers. Then you'd be ok. I use to have thm on my old car in the 80's.

 

[ES1]

up
offers?

 

[ES1]

up again

 

[G-Force]

Is there a breather port on these? I dont see it.

 

[ES1]

You punch it out and install a grommet

 

[ES1]

50.00 shipped?

 

[RobsIron]

.

 

[corsair231]

They'll only fit with stock rockers unless you use the jrc spacers. Then you'd be ok. I use to have thm on my old car in the 80's.

Looks like the punch outs are too close to the ends. Did you have any interference problems being on the ends like that? Other than that they look pretty good.

 

[3.8L V-8 eater]

Looks like the punch outs are too close to the ends. Did you have any interference problems being on the ends like that? Other than that they look pretty good.

Wow this thread was brought from the dead!!

 

[charlief1]

Looks like the punch outs are too close to the ends. Did you have any interference problems being on the ends like that? Other than that they look pretty good.

My old car was an H body Skyhawk and never really had any issues, other than having to change the gaskets about once a year.