One more try with the 3.5

[J-B Racing]

Still looking for a 3.5`` Down Pipe that will clear ATR HEADERS
for external WG. and NOT China Chit..

God Bless America...:smile:

 

[Eticket]

FYI.. there has never been one mass produced. There's too much variability in frame mounts, motor mounts and header to make one consistent to market.

Unless you have a HUGE turbo and running faster than 9.80's.. you probably dont' need to bother with a 3.5".. a 3.0" has been proven down to 9.4's..

It will be custom if you find one - a 3.5".

 

[affordablegn]

3.5 Downpipe

I have a 3.5" downpipe and tried it with ATR headers.
It just didn't fit!!!
I ended up using a 3" for ATR headers.
It swings way out and then down thru the hole.
Does your car have air yet.
Mine does and it was a tight fit with the 3".
Jack Cotton might be able to make you one.
I have seen some of his nice work.
Also, my 3.5" downpipe is NOT for sale.
I will use it on my next project.
Good luck on this one!
Jason
AffordableGN

 

[J-B Racing]

I have a 3.5" downpipe and tried it with ATR headers.
It just didn't fit!!!
I ended up using a 3" for ATR headers.
It swings way out and then down thru the hole.
Does your car have air yet.
Mine does and it was a tight fit with the 3".
Jack Cotton might be able to make you one.
I have seen some of his nice work.
Also, my 3.5" downpipe is NOT for sale.
I will use it on my next project.
Good luck on this one!
Jason
AffordableGN

I was lucky to get my ATR 3`` back from the person I had sold it too.
The car should and will run in the 9.50`s range. This was a long shot. I just would of saved some time maiking one. I have done DP`s and Exhausts before, just a PITA...

Later
Joe