One question about AlkyControl in-car wiring

[BlackMetal]

One wire isn't mentioned in the instructions, or maybe I just missed it.

So you have the red and tan wires hanging down from the low level light bulb that you install in one of the empty dash light slots. The instructions say in bold lettering to connect the tan wire from under the hood (low level sender) to the tan wire that you have hanging under the dash. I see no mention of where the red wire from that bulb is supposed to go, though. Connect tan to tan, connect red to _______ ?

I don't have enough electrical experience that I want to guess where it goes.

Thanks.

 

[daturbosix]

id imagin any 12v source would work

 

[jamier]

red wire

if i remember it goes to the other power wire for the light that goes in the power injection slot i think i wired mine together but not sure i'll look for my instructions but i remember all the wires were mentioned in the instructions check again

 

[Razor]

3 reds go together. Low Level Red, Power Injection Red, and Pump cable Red.

HTH

Julio

 

[BlackMetal]

Ok, I just didn't want to assume just in case. About to head out now and try to finish it up, been doing it bit-by-bit when I'm not at work.